Cellular Data Modem CM 900

The Data Connect Cellular Module 900 is an OEM module that uses the Advance Mobile Phone System (AMPS) cellular network for data transmission. AMPS is the cellular system used in Latin America, Australia, New Zealand, and parts of Africa. The AMPS System isn’t compatible with the GSM system used in North America, Europe and Asia.

The DCE CM-900 has a RS232 Interface and supports the popular AT command set normally associated with modems.

The DCE CM-900 is used by OEM customers in following areas

• Packet Data Radio
• SCADA and Telemetry System
• Remote Gas / Water / Electric Meter Reading
• Factory Automation Systems
• Vending Machines

The DCE CM-900 uses non-volatile memory to store configuration. Therefore, the DCE SM-900 doesn’t require configuration before startup.

The requirements to operate the DCE CM-900 are a host PC with a terminal program like Hyper Terminal or ProComm etc. and MIN & SID information from your cellular service provider.

The DCE CM-900 is packaged with an antenna, flat RS232 cable, and a manual.

Features

• AMPS Cellular Network
• MPN10-EC
• AT Command Set
• Standard RS232 Serial Interface
• Choice of Hardware or Software Flow Control
• Quiet Mode for “Non-Intelligent” machines

Specifications

Air Speed:
Up to 9600bps

DTE Rate:
300, 1200, 2400, 4800, 9600, 19200, & 57600 (Switch Selectable)

Auto Detection:
On Receive

Data Compression & Error Correction:
MMNP2-5, V.42, V.42bis, MNP10, & MNP10-EC are supported

RF Power Output:
0.6 watts

Power Supply:
10-18VDC, at 600mA when sending data, and 800mA maximum at startup

Interface:
RS232, Asynchronous

Signals Supported:
TXD, RXD, CD, DSR, RTS, CTS

Operating Temperature Range:
-30°C to +75°C

Dimensions:
“L x “W x “H

Ordering Information

DCE/CM-900 OEM Cellular Modem